Go to TOP

ANENG VD901 AC 12V-1000V Electrical Non Contact Voltage Detector Test Pen Probe Tester yellow

Product code: PHO_0CS5UIVU
Flash Deals533114

$11.20  $11.55 $14.36 

SOLD OUT
22% OFF
Quantity:
ANENG VD901 AC 12V-1000V Electrical Non Contact Voltage Detector Test Pen Probe Tester yellow
Ship to: FREE SHIPPING to United States via YUNTU--EU Priority Line Registration  
Supplier:Divya_C
Rank:4.6
Buy More... Get Lower PricesYes! We Ship To  us

Payment Guarantee:smile
Shipping Support:smile
Share To:

What Do Customers Buy Together With This Item?

.
ANENG VD901 AC 12V-1000V Electrical Non Contact Voltage Detector Test Pen Probe Tester yellow
22%
OFF
ANENG VD901 AC 12V-1000V Electrical Non Contact Voltage Detector Test Pen Probe Tester yellow
$11.20  $11.55 
.

AC voltage detection range selection, when the tester is turned on: about 48 ~ 1000V.Gently press the switch key (S) , and the indicator is on. The voltage range is about 12 ~ 1000V.

When the tester is not operated for about 5 minutes and no voltage signal is detected, the tester will shut down automatically.

When the battery voltage is lower than about 2.6v, the power indicator flashes for 3 times, and the buzzer will automatically shut down. Please replace the battery in time.

.

Description:

Item type: Test Pen

Package includes:

1 * Test Pen

Notes:

Operating instructions:
1. start the tester: press the power on key, self-check the tester, flashlight, indicator light of induced voltage signal, signal strength indicator light (high, medium and low), the button indicator light flashes once at the same time, and the power indicator light is always on.Turn off the tester: when the tester is on, press the power on key and it is off.
2. Under the starting state of tester, press the key to turn on the flashlight and turn on the flashlight.
3. turn off the flashlight: in the flashlight on state, press the flashlight on key, put out the flashlight.If the flashlight is not turned off, it will automatically go out in about 5 minutes.
4. ac voltage detection:
Insert the probe of the tester into a power socket or close to a live wire. When the tester detects ac voltage signal, the indicator light of induced voltage signal flashes. According to the detected signal strength, the tester lights up the corresponding signal strength indicator (high, medium and low), and the buzzer emits alarm sound of different frequencies.When ac voltage signal is sensed, L signal strength indicator light (low) flashes;When a higher ac voltage signal is detected, the M signal strength indicator (middle) is long on;When the highest ac voltage signal is sensed, H signal strength indicator lamp (high) 3 grain lamp flashes.
5. Separate the two wires to be tested as far as possible, and then use the probe of the tester to get close to the wire respectively. If it is a socket, insert the probe into the socket. The tester detects the wire with strong induction signal, and the zero wire with weak or no induction signal.

1-2cm error might exist due to manual measurements, please kindly understand. The colors deviation might differ due to different monitor settings.

.
Date Launched: Sep 24 2019
Previous     Next
All categories 