Light in the measurement of the output voltage and the input voltage is the same,needs to be connected to more than 20 w load can measure the output voltage
Alternating current (ac), the output is also an alternating current,it is not a direct current (dc)
The above, said 4000 W, is the point at which work load energy impedance,
Inductive load is 1/3 impedance load,load impedance refers to light, heat wire, etc,Inductive load is only series motor, etc.
.Description:
Product category:SCR Voltage Regulator
Size: Length 84.8 * Width 70 * Height 40mm, without protruding buttons and connectors.
Maximum power: 5000W (instantaneous limit power of resistive load). Long-term use should be reduced. It is recommended to use within 2200W resistive load (key parameters, please note)
Working voltage: AC 220V
Regulated voltage: 0-220V AC (from high to low can be changed to 0, from low to high about 20V)
Packing list:
1 set SCR Voltage Regulator
Note:
Please note that the load must be connected before adjusting the voltage.
SCR is mainly used for resistive loads (electrically heated incandescent lamps, etc.), most single-phase AC
.
