Stable performance: The heating plate is made of military-grade PCB, and the performance is stable

Design: The power line is fully covered with copper cover design, which can increase the current and heat generation

Good heat dissipation:Using oversized and large power heat sink to dissipate heat better

High power: Using six IRFP260 and 12 capacitors in parallel resonance, the power is high and the efficiency is high

Description：
product Category: Heating Machine
Model:A52357
Material: metal + plastic
Color: Black
Input voltage: 12V-48 recommended above 36V
Power requirements: less than 12V ≥ 10A 15V or more ≥ 20A
Maximum power: 2500W
Maximum current: 50A
Size: 25x12x9cm (Manual measurement, error about 3mm, please understand)
Features:
●The heating plate is made of military-grade PCB, and the performance is stable;
●The power line is fully covered with copper cover design, which can increase the current and heat generation;
●Using oversized and large power heat sink to dissipate heat better;
●The output terminal uses three M4 copper columns in parallel, which can be connected to other outputs such as high voltage package;
●Using six IRFP260 and 12 capacitors in parallel resonance, the power is high and the efficiency is high;
Note:
The power of heating is very large, except that the plate and components are hot, and the heat of copper tube is very high. The buyer can prepare water cooling system separately, can buy a small water pump and 2 meters of inner diameter Of 4mm rubber hose.
2. You must pay attention to when using switch power supply, because the high-power switching power supply usually have soft start function, the same output voltage is slowly rising, and if the voltage rise to 10V before By lacking voltage lead to circuit can't afford to vibrate, so that the two MOS tube conduction and burned components at the same time, so be sure to switch the power supply voltage stability and then access the induction heating circuit.
3. When heating the metal objects do not to heat too large metal, otherwise it may be overloaded with power, please add a 35A fuse or ammeter and air switch will be better. (package does not inclues)
4. Although this drive plate can withstand more than 40A current, but it is recommended that not exceed 48V 35A to prevent accidents and damage.
5. Package comes with heating circle diameter is 60 mm, design voltage is 36V, if you use more than 40 voltage power supply shall be used for inner diameter 70 mm above diameter heating ring, water pump use 12V dc power supply, please use separate Power supply voltage regulator module to burn out fan and water pump.
6. The minimum input voltage of the module is 12V, it doesn't mean all the 12V power supply can be used, some novice buyers may use a smaller power supply. This module has specific voltage and current
Content：
1*PCB board (with dual fans) 
1* copper tube
Note: All images and descriptions are for illustrative purposes only. The color deviation is subject to actual system configuration and slight dimension difference is allowed due to manual measurement.