Speedybee F7 AIO flight controller for RC drone FPV racing.
Support 4in1 ESC, 8 PIN connector or Solder Pads Two connection methods.
Built-in Bluetooth chip.
Zero configuration, connect to the Speedy Bee App directly after powering on, easy to set the FC parameters.
.Specifications
MCU: STM32F722
IMU: ICM20689
Baro: BMP280 (I2C)
OSD: BetaFlight OSD w/ AT7456E chip
BLE Module: inner connect to UART3 for remote setting with SpeedyBee App or other similar apps
BlackBox: 32MB onboard dataflash
Current Sensor: 200A(Scale 102)
BetaFlight Camera Control Pad: Yes
Power input: 3s - 6s Lipo
Power output: 5V *5(Including BZ+), the maximum load current is 2.5A. 9V * 1, the maximum load current is 2.5A.
ESC power output: 4 * VCC output
UART: UART Pads * 4(UART1, UART2, UART4, UART5)
RSSI input: RSSI input solder pad
SmartPort: Use Softserial1 to support SmartPort
I2C: Used for external Magnetometer, Sonar, etc.
Buzzer: BZ+ and BZ- pad used for 5V Buzzer
ESC signal: S1 - S5
LED pin: Used for WS2812 LED
Boot button: Used to easy enter DFU mode
Weight: approx. 8.8g
Dimension: approx. 36.5*44*7mm
Packing list:
1 * Flight Controller
Note: Due to manual measurement, it may vary from 1 cm to 3 cm. The colors deviation might differ due to different monitor settings, please kindly understand.
.
