Upgraded version of Radiolink AT10,with DSSS and FHSS dual signal
Higher accuracy of anti-interference and transmitter control bars than AT10.
Multiple function remote control system, Including helicopter,airplane and slider three type flying machine and five models,cover almost every popular model,you can fly any model by this radio.
3.5 inch colorful screen 320×480 resolution,clear display menu and graphs.
Fast response time only 3ms to the operation,faster then the other transmitter 20ms,even ten channels also let you feel it.
High channel resolution reaches 4096,0.25us per resolution let all the servos keep tranquil.
.Description:
Type: Radiolink AT10II 10 Channel transmitter set
AT10II Transmitter:
Frequency 2.4 GHz ISM band (2400 MHz to 2485 MHz)
Modulation Mode QPSK
Channel Bandwidth 5.0MHz
Spread Spectrum DSSS, FHSS
Adjacent Channel Rejection > 38dBM
Transmitter Power < 100mW (PCB test), < 20dBm (3 meter air test)
Operating Current < 95mA
Operating Voltage 8.6~15V
Control Distance 800 meters ground
Channel 10 Channel
Simulator Mode Under the simulator model the transmitter action turn off, change to power saving model
Screen 16 colorful screen
Size 78 x 52mm
320*480 pixel
Compatible Model Include all 120 degrees and 90 degrees swashplate helicopter, all fix wing and glider, five flying model.
Size 18 x 9.5 x 22 cm
Weight 0.95 kg
R12DS Receiver:
Frequency 2.4 GHz
Channel 12CH, support SBUS and PWM signal output
Working Voltage 4.8-10V
Working Current 38-45 mA (input voltage: 5V)
Dimension 50x31.5x14.5mm
Weight 14g
Control Range About 4KM Air
(Maximum range testing in unobstructed areas free of interference and may vary depending on local regulations).
Two signal working mode of R12DS:
(1)PWM signal output working mode: red LED indicates PWM signal output, 11 channels Totally.
(2) S-BUS signal output working mode: blue/purple LED indicates S-BUS signal output, 12 channels totally.
S-BUS and PWM signal working at the same time. S-BUS signal channel(3 pin of row 11) output 12 channels S-BUS signal, PWM signal channels(3 pin of row 1 to row 10) output CH3 to CH12 PWM signals, but 12 channel in total. How many PWM signal channels you can use depends on how many S-BUS signal channels you have used(e.g: you have use 4 S-BUS signal channels, then you have 8 PWM signal channels to use).
How to match code with transmitter:
1. Put the transmitter and the receiver close to each other within 1 meters.
2. Turn on the transmitter, then power on the R12DS.
3. Connect CH3 of R12DS to ESC.
4. There is a black button on the R12DS, use a thin stick press the button twice in two seconds, receiver light starts blinking, after about blinking 8 times, match code success and receiver signal LED always on.
Packing list:
1 x Radiolink AT10II 10 Channel transmitter
1 x Receiver
1 x PRM-01 module
Note:Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
.
