Using MPU6000 sensor and connected via SPI bus to improve the sampling rate of the sensor.
F4 master to improve the operating frequency of the program.
Providing higher control accuracy and faster The speed of response.
The integrated OSD comes with Betaflight online tuning, used in the current horizon four-axis small brushless four-axis rack.
Light weight, small size, low thickness and so on.
For receiver configuration, SBUS/IBUS and DSM receiver inputs, configure RX2 as the input interface.
.Description:
Item name: flight controller
Flight control configuration:
CPU: STM32F411CEU6
Sensor: MPU-6000 three-axis accelerometer / three-axis gyroscope (SPI connection)
Power supply: 1-2S battery input (DC 3.2V-8.4V)
BEC: Built-in buck-boost circuit (1S input BEC output 0.5A, 2S input BEC output 1.5A)
Receiver: PPM, SBUS, IBUS, Spektrum DSM2/DSMX, 1024/2048.
Built-in OSD interface
Led_Strip interface
BUZZER buzzer interface
UART1: TX1 (picture transfer), RX1
UART2: TX2, RX2 (for receiver)
Three sets of BEC output pads
Support BLheli suite ESC programming
Built-in voltage detection
Board size: 28.5*28.5MM
Screw hole spacing: 24.5*24.5MM diameter 3.0MM
Board weight: 3.0 g
Brushless ESC configuration:
Power supply: 1-2S
Current : 5A continuous peak 7A (for 2 seconds)
Support BLHeliSuite programmable
Factory firmware: S_H_50_REV16_7.HEX
Signal support: D-shot150, D-shot300, D-shot600, Oneshot125, Multishot, PWM
Package includes:
1 x Play F4 whoop flight controller
4 x 3P*1.25MM in-line sockets
1 x Power plug wire
Note:
The colors deviation might differ due to different monitor settings, please kindly understand.
.
