JHEMCU F4, using STM32F405 processor and MPU6000 gyroscope/accelerometer, integrated OSD, built-in 5V/2A , 8V/3A BEC. Two independent BEC work separately, optimized circuit design, premium hardware, further ensure powerful performance of flight control.
Convenient interface definitions, leaving available interfaces. 8P and 6P 1.0MM sockets are designed to facilitate direct input of the plug wire. Reserve black box TF deck, support up to 32G card, record flight data with 16kHz recording rate.
.Specification
Product Name: RC Flight Controller
Model: JHEMCU F4
Main control chip: STM32F405RGT6
Gyro: MPU6000
Barometer: None (reserved pad)
OSD chip: AT7456E
Black Box: TF deck
LED programming: support
BB ring: support
Input voltage: 2-6S
I2C interface: support
BEC-1: 5V/2A (internal power supply, receiver, LED, BUZZER, etc.)
BEC-2: 8V/3A (camera and picture transmission power supply)
Serial control port: three channels (UART1, UART3, UART6)
Flight Control Firmware: Betaflight
Hole position and damping ball hole position conversion: 30.5*30.5mm, φ4mm
Flight control size: 36*36mm
Weight: 6.9g
The Specific Meaning of Marks on F4 Betaflight Flight Controller
GND: Ground
+5V: BEC 5V 2A cont. MAX.2.5A
3.3V: LDO3.3V, MAX.300MA
VBAT+: share Lipo power
CUR: ESC Current signal input
S1,S2,S3,S4,S5,S6: ESC Signal
VTX: Video output for video Transmitter
VIN: Camera Video input
8V: Current 3A, video Transmitter and Camera Power supply
BZ-: General active 5V buzzer for dbuz 5V
RSSI: Receiver RSSI INPUT
LED: WS2812 LED signal
SCL&SDA: I2C_SCL & I2C_SDA
PPM: PPM RC Receiver Input
SBUS: SBUS RC Receiver Input
D/I: DSM and IBUS RC Receiver Input
(RC Receiver,SBUS,IBUS,DSM: RX1 )
T1: UART1 TX1
R3&T3: UART3 RX3 and TX3
R6&T6: UART6 RX6 and TX6
Packing list
1*JHEMCU F4 Flight Controller
Notice:
All images and descriptions are for illustrative purposes only. Product specification, functions and appearance may vary by actual usage. The color deviation is subject to actual system configuration and slight dimension difference is allowed due to manual measurement.
.
