Compatible with all major FPV receivers from vendors such as Fatshark, ImmersionRC, etc.
Supports the standard 40-channel set: band A, B, E, Fatshark, and Raceband.
Smart audio input allows remote control by the flight controller .
All parameters art controllable via push-button on the side of the unit.
LED Indicators of Channel, Band and Power. Allow easily check VTX Parameters by glancing at the quad.
Built-in Microphone, so you can listen to your motors while flying.
.Specification:
Brand Name: Holybro
Tekko32 F3 Metal ESC
Item Name: 65A BL_32 DShot1200 ESC
Quantity: 4Pcs
Con. Current: 65A
Peak Current: 80A
Input Voltage: 3-6S Lipo Support
Ext. cap needed for 6s (220uf 35v for 6s usage.)
- F3(M4 Core) MCU, Runs BLHELI32 firmware, the MCU works at 108Mhz
- Mosfet tested at 4S 65A, under props, nothing covered for 1min
- Onboard WS2812B LED
Size: approx. 18 x 27 mm
Weight: approx. 4.4g/pc
Kakute F7 V1.5 AIO ( Manual)
MCU: STM32F745 32-bit processor
IMU: MPU6000 (SPI)
Barometer: BMP280
Current Sensor: Approx. 130 amps
USB VCP Driver (USB does not take up a UART)
6 hardware UARTS (UART1,2,3,4,6,7)
All UARTS support hardware inversion. SBUS, SmartPort, and other inverted protocols work on any UART
Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not supported.
TF card for Blackbox logging
Dimensions: approx. 35x48x7mm
Mounting Holes: Standard 30.5mm square to center of holes
Weight: approx. 11.2g
Atlatl HV V2:
Item Name: 5.8G 40CH 25/200/500/800mW FPV Transmitter
Model: Atlatl HV V2
Transmitting Output Power: 25mW/ 200mW/ 500mW/ 800mW Switchable
Audio: 6 MHz + 6.5 MHz Mono
Antenna Connector: MMCX
Input Voltage: 7-28V (2-6S Lipo)
Dimension: approx. 35(L)x 25(W)x 7(H)mm
Mounting Hole: approx. 30.5x30.5mm
Weight: approx. 9.3g
Packing list:
4 x Holybro ekko32 F3 Metal ESC 65A
4 x 35V 220uF Capacitor
4 x 24AWG 100mm Black wire
4 x 24AWG 100mm White wire
4 x 24AWG 100mm Blue wire
4 x 16AWG 100mm Red wire
4 x 16AWG 100mm Black wire
1 x Kakute F7 V1.5 Flight Controller Board
1 x Atlatl V2 FPV Transmitter
1 x 80mm SMA--MMCX Cable
1 x 150mm 4pin JST GH wire
.