--Betaflight OSD. Change PIDs, adjust common configuration parameters, and change video transmitter channel and power level, all using your transmitter sticks and goggles.
--Soft-mounting built in. The IMU ("gy ro") chip on this board is mounted on vibration-isolating foam. This means that there is no need to soft-mount the board itself.
--High-performance / low-noise / high sensitivity IMU. ICM20689 with 6-axis gy ro and accelerometer. Can run at up to 32 kHz sampling rate.
.Description:
Product categories: Flight Controller
Kakute F7 Flight Controller:
MCU: STM32F745 32-bit processor
IMU: ICM20689 (SPI)
Barometer: BMP 280
Current Sensor: Approximate 130 amps maximum measurable value
USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART)
6 hardware UARTS (UART1, 2, 3, 4, 6, 7)
All UARTS support hardware inversion. SBUS, SmartPort, and other inverted protocols work on any UART without "uninvert hack".
Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not supported.
TF card for Blackbox logging
Dimensions: 35x41x7mm (including foam-mounted Gy ro board in height)
Mounting Holes: Standard 30.5 mm square to center of holes
Weight: 9g
Tekko32 F3 4in1 40A ESC:
32bit ESC with BLHELI32 firmware
Supports 3-6S lipo input
PWM input, TLM support
Voltage output (VBAT)
NO BEC
Supports oneshot/Multishot/Dshot PWM
Mounting holes 30.5x30.5mm
Supports damped light
F3 MCU, runs double faster than F051
Extra Cap needed for high current or 6S usage
Dimensions: 44x37x6mm
Weight: 11.6g
Packages:
1 x Kakute F7 Flight Controller
1 x Tekko32 F3 4in1 40A ESC
1 x Electrolytic capacito: 1000uF 35v
1 x 8pin to 8pin 1mm pitch 65mm cable
1 x 8pin to 8pin 1mm pitch 25mm cable
Note:Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
.
