--Soft-mounting built in. The IMU ("gy ro") chip on this board is mounted on vibration-isolating foam. This means that there is no need to soft-mount the board itself.
--High-performance / low-noise / high sensitivity IMU. ICM20689 with 6-axis gy ro and accelerometer. Can run at up to 32 kHz sampling rate.
--Ready for autonomous flight: Integrated BMP280 barometer and SCL/SDA pads for use with external GPS/magnetometer units.
--2 oz. copper PCB allows up to 120A maximum continuous current.
.Description:
Product categories: Flight Controller
Kakute F7:
MCU: STM32F745 32-bit processor
IMU: ICM20689 (SPI)
Barometer: BMP 280
Current Sensor: Approximate 130 amps maximum measurable value
USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART)
6 hardware UARTS (UART1, 2, 3, 4, 6, 7)
All UARTS support hardware inversion. SBUS, SmartPort, and other inverted protocols work on any UART without "uninvert hack".
Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not supported.
TF card for Blackbox logging
Dimensions: 35x41x7mm (including foam-mounted Gy ro board in height)
Mounting Holes: Standard 30.5 mm square to center of holes
Weight: 9g
Tekko32 F3 4in1 40A ESC:
32bit ESC with BLHELI32 firmware
Supports 3-6S lipo input
PWM input, TLM support
Voltage output (VBAT)
NO BEC
Supports oneshot/Multishot/Dshot PWM
Mounting holes 30.5x30.5mm
Supports damped light
Weight: 11.6g
Atlatl VTX:
Output Power: 0.5 mW (pit mode), 25 mW, 200 mW, 500 mW, 800 mW
Audio: 6.5 MHz Mono
Antenna Connector: MMCX
Input Voltage: 7 to 28 volts (2-6S LiPo) with absolute maximum 42 Volts
Dimensions: 35x25x7mm (Includes USB height)
Mounting Holes: Standard 30.5 mm square to center of holes
Weight: 9.3g
Packages:
1 x Kakute F7 +Atlatl HV V2 stack
1 x Tekko32 F3 4in140A ESC
1 x Tekko32 F3 4in1 40A ESC
1 x Electrolytic capacito: 1000uF 35v
1 x 8pin to 8pin 1mm pitch 65mm cable
1 x 8pin to 8pin 1mm pitch 25mm cable
Note:Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
.
