Remove nozzle and extension tube.
Flip through the filter box components.
Open the filter housing by pushing the side of the housing.
When you press the side of the filter housing, the top and bottom will unlock.
Pull down the lid and remove the filter pad. Rinse the filter pad to remove any debris.
Remove the pump and clean the inside of the pump.
Reassemble pump and filter kit.
.Description:
Item type: Fountain
LED: white light
Voltage: 220 v
Maximum flow rate :600L/H
Power: 10 w
H: 0 to 30 cm
Weight: 629g
Size :12x 8 x7.5cm / 4.7x3.1x 2.9inch
Extension tube length :12.5 cm to 23 cm
Cable length :190cm
Package includes:
1 x pump
1 x instruction
1 x fittings bag
Notes:
Warning
Shock hazard. The pump is equipped with a ground conductor and a ground connection plug. To reduce the risk of shock, make sure it is only connected to a properly grounded grounding socket.
- do not exceed the voltage shown on the pump.
Be sure to disconnect the pump from the power supply before starting any maintenance or pump operation.
Check the power cord for damage before installation and/or maintenance. If damage is found, replace the entire pump assembly.
Do not unplug the grounding pin from the power cord plug.
To reduce the risk of electric shock, use only on any portable individual fountain not exceeding 5 feet in size.
Shock hazard - the pump has not been investigated in swimming pools or Marine areas.
Matters needing attention
This pump has been evaluated for water only.
Use the appropriate power supply indicated on the pump label.
Keep the power cord away from high temperature or other heat sources.
Do not pump heated liquid.
Don't let the pump run dry. The pump must be completely submerged to function and cool.
Operate in fresh water only. Avoid using lots of chlorinated water and water with a high pH.
Do not lift the pump through the power cord.
The colors deviation might differ due to different monitor settings.
.