DIY replacement kit universal for damaged 3D printer hot end, special for Anet A2 & A8 printer.
Pre-wired NTC3950 thermistor, 100K ohm, 1.1m in length.
12V 40W 6*20mm cartridge heater.
Aluminum heater block.
0.4mm output nozzle.
6mm diameter external thread extruder throat, 30mm length, suits for 1.75mm filament.
.Specifications:
--NTC3950 Thermistor
Material: High Temperature Teflon(200℃)
Resistance: at 25°C=100K ohm
Cable Length: Approx. 1.1m
Working Temperature Range: -40℃~+300℃
-------
--Extruder Throat
Material: Stainless Steel & Teflon
External thread: M6
Inner diameter: 2mm
Length: 30mm
Filament diameter: 1.75mm
Input diameter of Teflon tube: 2.3mm
Output diameter of Teflon tube: 4mm
-------
--Nozzle
Color: gold
Material: Brass
Size: 6 * 13mm
Input Diameter: 1.75mm
Output Diameter: 0.4mm
External Thread Diameter: 6mm
-------
--Heater
Material: Stainless Steel
Voltage: 12V
Power: 40W
Wire Length: Approx. 1m
Diameter: 6mm
Length: 20mm
-------
--Heater Block
Material: Aluminum
Dimensions: 2 * 2 * 1cm / 0.8 * 0.8 * 0.4in(LWH)
Nozzle and nozzle hole: M6
Heater mounting hole diameter: 6mm
Mounting screw hole: M3;
Thermocouple mounting hole: M3
Suits for: Anet A2 & A8 & A9 3D Printer
Packing List:
1 * Set of Hot End
Note:
Please pay attention to the parameter before placing an order.
.